- Automotive Teaching Software
- Auto Engine Training Series
- Auto Chassis Training Series
- Auto Electric Appliance System
- Automotive Teaching Board
- EV Educational Equipment
- Electronic Training Series
- Electrical Maintenance Series
- Building Automatic Series
- Process Control Training Serie
- Sensor Training Series
- A/C And Refrigeration Trainer
- Motor Training Series
- PLC Training Series
- Pneumatic Hydraulic Series
- Mechatronics Training Series
- Industrial Robot Series
- Special Equipment Simulator
SOLAR POWER GENERATION SYSTEM TRAINER is a laboratory scaled unit designed to study all the parameters involved in the Solar System and Solar Energy direct conversion into electricity. The trainer is based on some application modules and photovoltaic solar panels. It is specially designed for the theoretical and practical study of the electrical installations with photovoltaic solar energy, the typical configurations used in photovoltaic installations and the operation of the different elements involved in the conversion.
Features:
- Training system control panel having rating of 500 VAand it Can be used as solar training system and also power generation as well.
- Training system control panel has built in DC voltmeters, DC ammeters, AC Voltmeter AC multifunction meter(for AC current,
voltage, power, frequency
- Training System Control panel has built in protection circuit for battery & solar panel
- Training system control panel have built in 30Aterminals for making the connection
- PCU (POWER AND CHARGE CONTROLLER UNIT): 1 No.,Control panel for experiments equipped with meters, connecting terminals and switches
Specifications:
Power and Charge Controller Unit:
- Inverter Capacity : 300-600VA
- Input Voltage : 190~260V AC
- Output Voltage on Mains mode : Same as input
- Output Voltage on UPS mode : 210~245V
- Output Frequency on UPS mode : 50Hz ±0.1Hz
- Output waveform on Mains mode : Same as input
- Output waveform on UPS mode : Modified Sine wave
- Battery Charging Current : 12A
- Efficiency at full load : >80%
- UPS overload & short circuit facility : Available
- Control panel design : Microcontroller Based,
- MCB: : C Type 16A.
Charge Controller Technologies:
- Solar PV Module : 24– 50V
- Current :25- 40A,
- Battery voltage : 12-24V
- Technology : MPPT
- Charging Stage : Bulk, Absorptions & Float
Meter specification:
- DC Voltmeter : 0-300V
- DC Ammeter : 0-40A
- Multi-Function Meter:
:Voltage-10-230V
:Current-100mA-5A
: Energy meter Display
Resolution- 0.001kWh
: Frequency-50Hz
Training platform used to conduct below experiment:
- Measurement and Analysis of Different parameters of Solar PV Module: open circuit and short circuit, parameter measurement with series and parallel PV modules
- I-V characteristic and Power curve of PV module and PV array
- Efficiency and fill factor Load Estimation and calculation Study of Charge controller
- Study of different parameter of inverter efficiency, PWM switching, charging of batteries, over load and over battery protection
Standard Accessories: Main cord, Patch cord & Operating manual
Electric Supply: AC240V
System Required Solar Panel and Battery
1. 250Wp/ 100Wp (PM) solar panel: 2 /1 Nos. (Voc : 43V, Isc : 7.75A,Vmp : 35V,Imp : 7.14)
2. Battery (12V) : 60A/100Ah: 1/2 Nos